ASSEMBLY GUIDE
Chairs With Wood Bases (Side Chair / Armchair)
1. After unpacking, place the leg base on a flat surface and lay the seat face down on a non-abrasive surface.
Placing a towel underneath a hard surface or the carpet works.
NOTE :
If you have purchased a Weave Side Chair, please discard and do not use black plastic washers.
These washers are intended for plastic Side Chairs and Armchairs only.
2. This is an extra step that we suggest because the screws sometimes loosen their grip during all the handling.
Using a regular wrench of pliers wrench, grip the screw nut, and tighten the screw with the allen wrench.
Sometimes, if the allen wrench loses grip, the reverse works better by affixing the allen wrench and tightening the nut.
Tighten until snug. Do not use maximum tension.
Using a regular wrench of pliers wrench, grip the screw nut, and tighten the screw with the allen wrench.
Sometimes, if the allen wrench loses grip, the reverse works better by affixing the allen wrench and tightening the nut.
Tighten until snug. Do not use maximum tension.
If the base is not level, simply grip the leg that is not touching the ground and it's opposite leg, and gently squeeze/flex inward to balance it out.
WireBase (Side & Arm Chair)
1.
After unpacking, set the chair on top of a flat surface (table works well).
2.
If the base is not level, simply grip the leg that is not touching the ground and it's opposite leg and gently squeeze inward to balance it out.
If the base is not level, simply grip the leg that is not touching the ground and it's opposite leg and gently squeeze inward to balance it out.
3.
Place the leg base on a flat surface
Tighten the 4 screws with the supplied allen wrench.
Start from the bottom 2 screws towards the edge of the seat
NOTE :
If you have purchased a Weave Side Chair, please discard and do not use black plastic washers.
These washers are intended for plastic Side Chairs and Armchairs only.
Start from the bottom 2 screws towards the edge of the seat
NOTE :
If you have purchased a Weave Side Chair, please discard and do not use black plastic washers.
These washers are intended for plastic Side Chairs and Armchairs only.
5.
To apply the feet to the base, simply align and apply pressure snapping the feet into place.
ROCKING CHAIR
Note that the front of the base is the left side
The wooden rockers are oriented with the smaller section facing front.
To connect the base to the seat, see the first section for "Chairs With Wood Bases (SideChair / ArmChair)"
PLEASE NOTE: When assembling our "Weave" Model-- the black washers can be discarded - With any assembly questions, feel free to contact our Customer Service Monger, Schuyler, at allgood@midcenturymonger.com ~_~
